某電廠畢業設計
2萬字 56頁

目錄
摘要 1
前言 1
第一章 緒論 2
1.1國內外研究及發展現狀 2
1.2焦作地理情況 2
1.3焦作電廠基本情況 3
1.4本課題的研究任務 4
第二章 電氣主接線設計及變壓器選擇 5
2.1電氣主接線設計原則 5
2.2電氣主接線設計的基本要求 5
2.3電氣主接線方案的擬定 7
2.4變壓器的選擇 11
第三章 短路電流計算 18
3.1短路電流計算的目的及短路電流計算條件 18
3.2電抗標幺值的計算 18
3.3短路電流計算 20
第四章 電氣設備的選擇 24
4.1電氣設備選擇的一般條件 24
4.2電器設備選擇 27
4.3進出線和母線的選擇 38
4.4母線支柱絕緣子的選擇 45
第五章 配電裝置 47
結束語 48
致 謝 49
參考文獻 50

摘要
本設計主要是針對焦作電廠的110kV一次系統，概述了焦作電廠設計的基本過程和基本方法。第一章概括介紹了國內外電力工業的研究及發展現狀和焦作電廠的基本情況，為后幾章提供所需的基本資料。第二章是電氣主接線和電氣設備的選擇，根據焦作電廠的原始資料擬定了主接線方案，確定發電機、主變壓器、高壓廠用變壓器和高備變壓器的容量和型號。發電廠電氣主接線是發電廠電氣設計的主體，與電廠運行的可靠性、經濟性要求等密切相關，對電器選擇和布置，繼電保護和控制方式等都有較大的影響。第三章對焦作電廠一次系統做了短路電流計算，為后面設備的選型提供了依據。第四章是一次系統電器設備的選擇，并在正常工作條件下和短路條件下對其進行校驗。第五章是針對配電裝置的設計，同時也是對前幾章內容的綜合概括。
隨著國民經濟和科學技術的發展，發電機單機容量在不斷擴大，這就對電廠的主接線形式和配套設備提出了更高的要求，同時也要求發電廠做到可靠、經濟、合理地運行，滿足人們對電能的基本需求。
關鍵詞：一次系統 主接線 短路計算 電氣設備 配電裝置



Summary
This design is to aim at making one subsystem of Jiao Zuo power station 110 kV mainly.Chapter 1 has generalized to introduce research of domestic and international electric power industry and present conditions and basic circumstance of Jiao Zuo power station that is basic data needed by several chapters later . Chapter 1 is a choice that connects line and the electricity equipments.According to the original data of Jiao Zuo power station to draft connect line form, capacities andt model numbers of generators, main transformers,the transformer the high pressure used by an factories, high the capacity transformers used in case.Connects the line is body of designs the power plant,.Credibility and economy standard of power station is closely related,it has bigger influence to choice and arrangement of the electric appliances, to the way of protection and control, etc.According to the technique data of chapter 2, do the short-circuit electric current calculation of subsystem in chapter 3, provides basises for the behind equipments. The choice of the subsystem in Chapter 4, it's carry on check electric of appliances equipments under the condition of normal hort-circuit condition. Chapter 5 is aim to the design of the配電裝置

Also is the synthesization of before part.
Along with the development of science and technology, single machine capacity of generator is extending continuously,it needs higher requests to connected the line form and the kit equipmentses of the power station, also request the power plant to attain the credibility, economy, reasonable movement, also satisfy the people's basic need that is the electric power.
Keywords：the subsystem，forms of main connected lines, short-circuit calculation，electricity equipments.


參考文獻
《發電廠電氣部分》 范錫普 中國電力出版社
《供電技術》 王崇林 鄒有明 煤炭工業出版社
《電力工程》 吳再希 熊信銀 華中科技大學出版社
《發電機及電氣系統》 熊信銀 中國電力出版社
《發電廠電氣部分》 牟道槐 重慶大學出版社