單片機紅外遙控系統設計

摘要 作為傳統的家用電器，隨著空調的普及，電風扇的市場地位受到了巨大的沖擊，傳統的開/關、調速功能已經不能滿足市場的需求。人們希望電風扇在體積小、作方便等的基礎上能夠擁有更多的功能，而紅外遙控的廣泛應用及單片機技術的成熟，則使得智能紅外遙控系統成為了電風扇的發展趨勢。
  本設計方案基于市場的需求，結合紅外遙控設計簡單、作方便、成本低廉等特點，采用了51單片機作為遙控發射接收芯片，HS0038作為紅外一體化接收發射管，在此基礎上設計了一個簡易的智能紅外遙控電風扇系統。系統包括接收和發射兩大部分，本文設計實現了幾項電風扇的基本功能：開/關功能、多級調速功能、0.5-7.5小時不同時間段的定時功能，以及自然、正常兩種風類的選擇功能。另外本系統有16個按鍵，可用于擴展控制其他電器。
關鍵字：紅外遙控；信號調制；編碼；解碼．

    The Design Of The Infared Remote Contorl Based On 51-MCU
Abstract：With the popularity of air conditioners, the market position of the electric fans which are the traditional household appliances will receive a huge impact, the traditional on / off and speed control function have been unfit for the needs of the market. It is hoped that the fans in small, easy to operate, and so on the basis can have more features. When the application of infrared remote control becomes wilder and technologies of SCM become mature, the  remote control system is the trend.                                                                 The design was based on the needs of the market. Considering that infrared remote control is simple, easy to operate, low-cost, I use a special launching and receiving chip which depends on remote control. On the basis of this chip a system of intelligent infrared remote-control was designed for the fan. The system consists of the launching part and the receiving part. This system is designed to achieve some basic functions of fans: on / off function, three kinds of speed, the timing function which can be chosen at different times of 0.5-7.5 hours, and the function of two kinds of wind which are the natural wind and the normal wind.
Key words: Infrared Remote Control; Signal Modulation; Encoding; Decoding。

 
目  錄
1緒 論 1
1.1課題設計目的及意義 1
2課題的方案設計與論證 3
3系統的硬件結構設計 4
3.1 系統方框圖 4
3.2 系統功能需求 5
3.3   51系列單片機功能特點[3] 6
3.4 紅外發射電路 10
3.5 紅外檢測接收電路 11
3.6 控制電路 12
3.7 電源電路設計 13
3.8 顯示部分的設計 14
3.9鍵盤設計 17
4 系統軟件的設計 19
4.1 定時/計數器應用 19
4.2遙控碼的發射 22
4.3 紅外接收 25
4.4 調速單元 27
4.4.1 調速原理 27
4.4.2 調速方法 27
4.5按鍵抖動問題 29
4.6 系統的軟硬件的調試 30
結論 32
參考文獻 33
附   錄 35
致  謝 47